0 Item(s)
$0.00
View Cart


FREE Shipping on orders over $149
1-866-558-3369

Accessories

We carry a wide range of accessories for installing electric radiant floor heat. Some accessories are required for all installations, such as a Digital Multi Meter, which is needed for installing all electric radiant floor heating products. Other accessories are only recommended, as they will make your installation much easier and will lower the risk of damaging the heating elements while installing them, such as a plastic trowel, which eliminated the risk of cutting a wire with the sharp edge of a metal trowel.

We also sell cork insulation, which can be installed underneath mats of cables that are being installed over a slab subfloor. Installing cork insulation will provide a thermal break between the heating elements and the cold slab, which will lower the start-up time of the system. Please note, however, that this will not make the floor get hotter—it will only make the floor get warm faster.

Ready for Heated Floors?

Installation is easy and we're here to help!

Floor heating basics Planning your layout videos

Default
Set Descending Direction
5

3 Item(s)

  1. Nuheat RLY20A220 Relay-240v Input

    Nuheat RLY20A220 Relay-240v Input

    Our Price

    List Price: $60.00

    Our Price: $57.00

    Nuheat 240 Relays are used when your floor heating amp load exceeds 15 Amps. Since the introduction of the Solo and it's new capabilities, we recommend using multiple Solos if your circuit load exceeds 15 amps instead of Relays. Call us for help! Nuheat Relays may be in stock; please call for assistance or to order. Learn More
  2. Nuheat RLY20A120 Relay-120V Input

    Nuheat RLY20A120 Relay-120V Input

    Our Price

    List Price: $60.00

    Our Price: $57.00

    Nuheat 120 Relays are used when your floor heating amp load exceeds 15 Amps. We typically recommend using additional thermostats if your circuit load exceeds 15 amps instead of Relays. Call us for help! Learn More
  3. Marker Plate Snow Melt WYF

    Marker Plate Snow Melt WYF

    Our Price
    Our Price: $59.00
    The ProMelt Snow Melting aluminum plaque mounts within the snow melting zone to permanently indicate where a snow melting system has been installed for enhanced safety. Building and Electrical codes typically require 1 visible marker per 400 Square Feet or separate area. Installing these permanent marker plates where they will be clearly visible is a good safety practice and help remind workers and future owners that electrical snow melting wires are installed within the surface. Learn More

Default
Set Descending Direction
5

3 Item(s)