Nexans TXLP 500 Watt Floor Heat Cable 120v requires 4.2 amps

96 Ft Long to Heat 34-41 Sq Ft (depends on spacing) Closer spacing means more heat and faster warm-up time. National Electric Code allows a MAXIMUM of 15 watts per Sq Ft for Indoor floors. So the lowest value Cannot be exceeded. A cable that covers 34-41 SF CANNOT be installed in a 25 Sq Foot area, as this would exceed the allowable Watts per Sq Ft (500 watts divided by 25 SF = 20 watts per SF)

Additional Information

More Nexans Information

Nexans TXLP 300 Watt Floor Heating Cable 120v requires 2.5 amps

60 Ft Long to Heat 25-33 Sq Ft (depends on spacing) Closer spacing means more heat and faster warm-up time. National Electric Code allows a MAXIMUM of 15 watts per Sq Ft for Indoor floors. So the lowest SF value Cannot be exceeded. A cable that covers 25-33 SF CANNOT be installed in a 15 Sq Foot area, as this would exceed the allowable Watts per Sq Ft (300 watts divided by 15 SF = 20 watts per SF)

Additional Information

More Nexans Information

Nexans TXLP 1060 Watt Floor Heating Cable for 120v requires 8.8 amps

204 Ft Long to Heat 86-105 Sq Ft (depends on spacing) Closer spacing means more heat and faster warm-up time. National Electric Code allows a MAXIMUM of 15 watts per Sq Ft for Indoor floor heating. So the lowest SF value Cannot be exceeded. A cable that covers 86-105 SF CANNOT be installed in a 53 Sq Foot area, as this would exceed the allowable Watts per Sq Ft (1060 watts divided by 53 SF = 20 watts per SF = too much!)

Additional Information

More Nexans Information

Nexans TXLP 730 Watt Floor Heating Cable for 120v requires 6.1 amps

141 Ft Long to Heat floors of 51-65 Sq Ft (depends on spacing) Closer spacing means more heat and faster warm-up time. National Electric Code allows a MAXIMUM of 15 watts per Sq Ft for Indoor floors. So the lowest value Cannot be exceeded. A cable that covers 51-65 SF CANNOT be installed in a 37 Sq Foot area, as this would exceed the allowable Watts per Sq Ft (730 watts divided by 37 SF = 20 watts per SF)

Additional Information

More Nexans Information

500 Sq Foot Kit contains 2350 Feet of WarmWire (2) 240160WD & (1) 240180WD Spools to heat 500 Sq Ft at 2-1/2 inch spacing (12 watts per Sq Ft), a Programmable & GFCI Protected electronic thermostat with built-in timer. This kit includes the following items packaged at the SunTouch Factory in the USA. Included in this Kit:

• Above 300 sq ft, 2 circuits are required so you receive 1 relay with the thermostat
• 3 spools of 240v WarmWire, to heat 500 sq foot
• 13 coils of WarmWire Strap 25 Ft in length (1 coil is needed for each 40 Sq Ft of WarmWire)
• Double sided super-sticky tape 3/4" wide x 108 feet long very thin and low profile to adhere the WarmWire Strap to the floor it works on concrete, plywood or concrete board to hold the strap in place while you install the WarmWire
• LoudMouth installation monitor for an audible warning if continuity is broken during installation simply connect the included 9-volt battery. Designed & patented by SunTouch contractors call this handy tool ?peace of mind?
• Installation Manual with all instructions, suggestions and examples of floor heating layouts
• Bilingual Installation DVD showing the entire installation process for your floor heating wire

And, Only from Warm Your Floor we include?

• Digital Ohm Meter for testing of your mats before, during and after installation FREE 9 volt battery included!
• WarmWire Tips & tricks, secrets from experienced installers gathered over many years

Additional Information See WarmWire Install Manual

480 Sq Foot Kit contains 2256 Feet of WarmWire (3) Spools to heat 480 Sq Ft at 2-1/2 inch spacing (12 watts per Sq Ft), a Programmable & GFCI Protected electronic thermostat with built-in timer. This kit includes the following items packaged at the SunTouch Factory in the USA. Included in this Kit:

• Above 300 sq ft, 2 circuits are required so you receive 1 relay with the thermostat
• 3 spools of 240v WarmWire, to heat 480 sq foot
• 12 coils of WarmWire Strap 25 Ft in length (1 coil is needed for each 40 Sq Ft of WarmWire)
• Double sided super-sticky tape 3/4" wide x 108 feet long very thin and low profile to adhere the WarmWire Strap to the floor it works on concrete, plywood or concrete board to hold the strap in place while you install the WarmWire
• LoudMouth installation monitor for an audible warning if continuity is broken during installation simply connect the included 9-volt battery. Designed & patented by SunTouch contractors call this handy tool ?peace of mind?
• Installation Manual with all instructions, suggestions and examples of floor heating layouts
• Bilingual Installation DVD showing the entire installation process for your floor heating wire

And, Only from Warm Your Floor we include?

• Digital Ohm Meter for testing of your mats before, during and after installation FREE 9 volt battery included!
• WarmWire Tips & tricks, secrets from experienced installers gathered over many years

Additional Information See WarmWire Install Manual

460 Sq Foot Kit contains 2162 Feet of WarmWire (1) 240140WD & (2) 240160WD Spools to heat 460 Sq Ft at 2-1/2 inch spacing (12 watts per Sq Ft), a Programmable & GFCI Protected electronic thermostat with built-in timer. This kit includes the following items packaged at the SunTouch Factory in the USA. Included in this Kit:

• Above 300 sq ft, 2 circuits are required so you receive 1 relay with the thermostat
• 3 spools of 240v WarmWire, to heat 500 sq foot
• 13 coils of WarmWire Strap 25 Ft in length (1 coil is needed for each 40 Sq Ft of WarmWire)
• Double sided super-sticky tape 3/4" wide x 108 feet long very thin and low profile to adhere the WarmWire Strap to the floor it works on concrete, plywood or concrete board to hold the strap in place while you install the WarmWire
• LoudMouth installation monitor for an audible warning if continuity is broken during installation simply connect the included 9-volt battery. Designed & patented by SunTouch contractors call this handy tool ?peace of mind?
• Installation Manual with all instructions, suggestions and examples of floor heating layouts
• Bilingual Installation DVD showing the entire installation process for your floor heating wire

And, Only from Warm Your Floor we include?

• Digital Ohm Meter for testing of your mats before, during and after installation FREE 9 volt battery included!
• WarmWire Tips & tricks, secrets from experienced installers gathered over many years

Additional Information See WarmWire Install Manualyo

440 Sq Foot Kit contains 2068 Feet of WarmWire (2) 240140WD & (1) 240160WD Spools to heat 440 Sq Ft at 2-1/2 inch spacing (12 watts per Sq Ft), a Programmable & GFCI Protected electronic thermostat with built-in timer. This kit includes the following items packaged at the SunTouch Factory in the USA. Included in this Kit:

• Above 300 sq ft, 2 circuits are required so you receive 1 relay with the thermostat
• 2 spools of 240v WarmWire, to heat 440 sq foot
• 11 coils of WarmWire Strap 25 Ft in length (1 coil is needed for each 40 Sq Ft of WarmWire)
• Double sided super-sticky tape 3/4" wide x 108 feet long very thin and low profile to adhere the WarmWire Strap to the floor it works on concrete, plywood or concrete board to hold the strap in place while you install the WarmWire
• LoudMouth installation monitor for an audible warning if continuity is broken during installation simply connect the included 9-volt battery. Designed & patented by SunTouch contractors call this handy tool ?peace of mind?
• Installation Manual with all instructions, suggestions and examples of floor heating layouts
• Bilingual Installation DVD showing the entire installation process for your floor heating wire

And, Only from Warm Your Floor we include?

• Digital Ohm Meter for testing of your mats before, during and after installation FREE 9 volt battery included!
• WarmWire Tips & tricks, secrets from experienced installers gathered over many years

Additional Information See WarmWire Install Manual

420 Sq Foot Kit contains 1974 Feet of WarmWire (3) 240140WD Spools to heat 420 Sq Ft at 2-1/2 inch spacing (12 watts per Sq Ft), a Programmable & GFCI Protected electronic thermostat with built-in timer. This kit includes the following items packaged at the SunTouch Factory in the USA. Included in this Kit:

• Above 300 sq ft, 2 circuits are required so you receive 1 relay with the thermostat
• 3 spools of 240v WarmWire, to heat 420 sq foot
• 11 coils of WarmWire Strap 25 Ft in length (1 coil is needed for each 40 Sq Ft of WarmWire)
• Double sided super-sticky tape 3/4" wide x 108 feet long very thin and low profile to adhere the WarmWire Strap to the floor it works on concrete, plywood or concrete board to hold the strap in place while you install the WarmWire
• LoudMouth installation monitor for an audible warning if continuity is broken during installation simply connect the included 9-volt battery. Designed & patented by SunTouch contractors call this handy tool ?peace of mind?
• Installation Manual with all instructions, suggestions and examples of floor heating layouts
• Bilingual Installation DVD showing the entire installation process for your floor heating wire

And, Only from Warm Your Floor we include?

• Digital Ohm Meter for testing of your mats before, during and after installation FREE 9 volt battery included!
• WarmWire Tips & tricks, secrets from experienced installers gathered over many years

Additional Information See WarmWire Install Manual

400 Sq Foot Kit contains 1880 Feet of WarmWire (2) 240200WD Spools to heat 400 Sq Ft at 2-1/2 inch spacing (12 watts per Sq Ft), a Programmable & GFCI Protected electronic thermostat with built-in timer. This kit includes the following items packaged at the SunTouch Factory in the USA. Included in this Kit:

• Above 300 sq ft, 2 circuits are required so you receive 1 relay with the thermostat
• 2 spools of 240v WarmWire, to heat 400 sq foot
• 10 coils of WarmWire Strap 25 Ft in length (1 coil is needed for each 40 Sq Ft of WarmWire)
• Double sided super-sticky tape 3/4" wide x 108 feet long very thin and low profile to adhere the WarmWire Strap to the floor it works on concrete, plywood or concrete board to hold the strap in place while you install the WarmWire
• LoudMouth installation monitor for an audible warning if continuity is broken during installation simply connect the included 9-volt battery. Designed & patented by SunTouch contractors call this handy tool ?peace of mind?
• Installation Manual with all instructions, suggestions and examples of floor heating layouts
• Bilingual Installation DVD showing the entire installation process for your floor heating wire

And, Only from Warm Your Floor we include?

• Digital Ohm Meter for testing of your mats before, during and after installation FREE 9 volt battery included!
• WarmWire Tips & tricks, secrets from experienced installers gathered over many years

Additional Information See WarmWire Install Manual