FREE SHIPPING on all orders over $149. Click here to learn more

Repair

Knowledge Center

  • Select Category:

Repair

If you cut the heating wire on accident, don't panic. There is a solution.

Repairing a Broken Radiant Heating Element

Need to repair Nuheat? CLICK HERE to go to the Nuheat repair section.

My SunTouch product isn't working anymore...

  • What do I do now?

    Floor heating system not working? No worries – it can be fixed and we can help.

    It doesn’t happen often, but floor heating systems can be damaged. Stuff happens, but you have come to the right place. Even if you don’t know what happened we can usually help you figure it out.

  • New Installation Problems:

    The floor is closed and I know where the damage is : Carefully remove tile or floor covering to expose the break.
    Repair the damage following the instructions included with the repair kit.

    I’m not sure why my floor stopped working, I need more help…
    Is  the Thermostat the problem? If you haven’t ruled out the stat? Start here : 

    Thermostats cannot be repaired in the field, only replaced, as there are no batteries or other serviceable parts. Always replace BOTH parts of the thermostat – the base which is mounted to the wall and connect to power AND the faceplate which is attached to the base. Repalcing only 1 piece will not solve your problem.

    If you have ruled out the thermostat, then we’ll have to dig a little deeper:
    My Floor Heating stopped working after Work was done in the room or to my floor (tile replacement, new toilet, tub or cabinet, drilled holes, etc). Since the floor was working before work was done, that spot is the first place I suspect.

    I know the wire is cut or pinched, but I do not know where.
    We have tools to help you trace the location of a break – but you can often save time and money if you know someone penetrated a floor that was previously heating fine, and go right to that spot to check for damage, so ask others and see if anyone remembers what might have happened. Here are some possibilities:

    Tile was removed – this is the likely location of a break. While it is possible to remove tile without damaging the floor heating elements below, this is frequent source of damage to the wires.Click here for tile removal tips

    If thinset is not fully cured, you may be able to add a little water in grout joints and carefully pry up a tile

    The heating elements may have been damaged during the repair or other work

  • The Heating wire was cut and the floor is still open, I know what happened and I see the damage.

    This is an easy one. Read the instructions, then order a repair kit. You need a few tools, including a heat gun.
    SunTouch Heating Wire Repair Manual (Mat & WarmWire)

    Order a repair kit – each kit has the complete instructions found above
    Heating Wire Repair Kit for SunTouch Mat or WarmWire(same kit)

    The wire is damaged near the end…Here you have 2 choices
    If it’s the last few feet, you can cut the wire at the break and perform an End Splice Repair Instructions
    If you want to preserve the last few feet of heated area, get a repair kit and Follow repair instructions above
    Purchase a power lead repair splice kit

    Power Lead Repairs if the power lead is cut or damaged:
    SunTouch Mats or WarmWire Power lead repair kit (this is a kit only for the power lead, not the heating wire)

    If you have to remove tile, TURN OFF THE POWER first, then connect your loudmouth or multi meter first. Click here for tile removal tips
    (If you have to remove tile, connect your loudmouth or multi meter)

    Tools that may help find a break in a heated floor that is not working for SunTouch mats or WarmWire
    Fault Finder : Loudmouth Monitor Alarm

Featured Articles

Schluter Systems DITRA-HEAT Warranty Update 2016

Schluter Systems DITRA-HEAT Warranty Update 2016

Read more