The SunTouch 500675 NON-programmable Thermostat's NEW clean design and features make it the Top rated Basic T-stat to control your Floor heating system.

This thermostat senses the FLOOR Temperature (Using the INCLUDED 15 foot Floor Sensor Wire) and has Built-in Ground Fault Protection for your safety. Listed by ETL to UL standards for use in the USA and Canada. No need for an additional GFCI circuit in most areas. Buttons are out of sight behind a single door at the bottom of the SunStat, just below the backlit digital display.

Push a button to raise or lower temperature or simply turn the system off.

This Thermostat is Dual Voltage - 1 thermostat for either 120v or 240v - You can't get it wrong!

Several New Features were added when creating this thermostat, which was released in Sept 2007 and is Manufactured by SunTouch - not outsourced like most manufacturers.

New Features make the SunStat a terrific value if you don't want programming features to control your Floor Heating System.

• Dual Voltage - 1 thermostat for Either 120v or 240 - never have the wrong thermostat on the job again
• Air-sensing Mode with a Floor Temperature override limit as an option
• Regulator mode if sensor is not connect or is damaged
• "Master" Control Capability - Each SunStat Pro allows other SunStat Relays to be connected to it to expand your system
• Class 2 Insulated Sensor ( 15' long) Wire which can run in the SAME CONDUIT as the power lead from you Floor Heater system
• 12 or 24 hour (military time) Display - your choice
• SmartStart Control

Other Features:

• Temperature Range (floor) of 40 to 99 degrees F (5 to 37 Celsius)
• Back Light for LCD screen
• Large Digital Display showing operation, mode, heat on/off, etc. LCD shows time and all functions
• Temperature displays in either F or C
• 15 Amp capacity to control up to 150 SF of SunTouch 120VAC mats per control and 300 SF of 240v SunTouch
• Can connect to NEW remote FloorStat Control unit
• Built-In Safety - Class A GFCI protection with GFCI test Light and button - 5 milliAmp trip
• 1 Year Warranty
• No Battery required
• Manual Setback / Vacation Mode for quick switching to Economy setting when leaving for an extended time

Included with Each Thermostat:

• 15 Foot Sensor Wire (Class 2 Insulated sensor - the best in the business) can be cut shorter if you choose
• Complete Instructions in English, Spanish & French
• Screwdriver included for use in installation
• Wire Nuts
• Mounting Screws

Additional Information

500675 Instructions PDF - Read, Print or save