FREE SHIPPING on all orders over $149. Click here to learn more

Sensor Wire 10K For DualTemp Thermostat

SKU 500802

More Views

$14.00

Shipping Information

This is an add-on item, that is eligible for FREE shipping as a part of an order over $149.

Details

This item has been DISCONTINUED and replaced by the 15' long 500110 sensor wire.

The 500802 Sensor wire adds floor sensing capability to the P-3285 DualTemp Thermostat (Patio Heating Only). It is a 10K thermistor design and is 10’ Ft long.

No Sensor is included with the P-3285 thermostat - you must purchase this sensor wire to use the P-3285 Thermostat for Patio heating.

Some customers order an extra sensor for 'peace of mind'. Although it is extremely rare for a sensor to fail, they think it is a reasonable precaution to install 2 sensor wires and they consider it cheap insurance.

If you choose to purchase 2 sensors, run both sensors from the Thermostat box to the floor below and then place them between the heating elements 12 inches or more into the heated portion of the floor. You can put them side by side, but connect only one to the thermostat control. If you ever need to replace a faulty sensor, you will have one at your fingertips; simply disconnect one, and connect the back-up.

A spare can come in handy if yours gets lost or damaged during installation.

Each Thermostat Manufacturer uses a different sensor wire.

Specifications

Specifications

Brand Name SunTouch Floor Warming
Manufacturer Watts Radiant
Instructions + Video

Instructions + Video

Instruction Manual
Install Steps
  1. Sensor wires installed within slabs are typically run in conduit into the heated area.
  2. Remove the thermostat cover by removing the white Screw Cover (located in the center of the thermostat cover) and the Cover Screw. Secure the Base Unit to the wall. Be sure to feed the electrical wiring (18-3 or 18-4) through the provided slot in the Base Unit and connect to appropriate terminal block(s).
  3. Connect the 500802 floor sensor to the corresponding floor sensor terminals, labeled NTC, the first two terminals on the right terminal block.
  4. Replace the Cover, Cover Screw and Screw Cover.
Location / Use : Indoor Only Outdoor Only
More Details

More Details

Made In USA Made in USA

Compatible Products

  1. 13 Watt Roof & Gutter Plug-in Cable - 50ft

    13 Watt Roof & Gutter Plug-in Cable - 50ft

    Leave the First Review

    Regular Price: $250.00

    Special Price $197.40

    Learn More

Have a question?

Check out our Knowledge Center

or give us a call!

1-866-558-3369

Mon - Fri 6:30am to 5:00pm PST