RPM-V1 Radiant Positioning Mat with Holes 5/16" x 20" x 44" (6.11 Sq Ft)

Rating:
100% of 100
Availability: In stock
SKU
RPM-V1
$14.95
Now with holes for easier installation on wood (NO staples required) and the ability to use lower cost adhesive on concrete. RPM-V1 Mats make the installation of floor heating cable fast and easy when using self leveling mortar. RPM-V1 Mats are 20” x 44” and Made from Heavy Duty 60 mil ABS plastic (80%+ recycled materials) but weigh only 2.0 lbs. Our most popular thickness is 5/16” and has been used to install thoUSAnds of WarmWire® projects providing a lightweight, quick and clean option to a traditional backer board and cable guide strap installation. Simply thread the floor heating cable of your choice (not included) onto the grid between the studs at your desired spacing and it sits safely and securely 1/8” below the top of the studs so your installation is protected from traffic and tools. Once filled with cement leveling mortar your floor has a lab tested and approved “heavy” rating with a lower profile than ¼” backerboard. Plus it is lighter weight and installs in half the steps! On concrete slabs, it’s rated “High Performance” as an anti-fracture membrane in testing. Studs are ½” in diameter and spaced at 1”.
Indoor / Outdoor

Yes

Install Steps

RPM-V1 Plywood installation summary:

Read Complete RPM-V1 Mats installation instructions for Plywood or OSB

  1. 1. Spread Roberts 2001 Adhesive or equivalent on Plywood using 1/8x1/8 v-notch trowel
  2. 2. Cut & Lay RPM mats into adhesive, lining up studs and butting sheets together without overlap. Then Wait 24 hours for adhesive to dry.
  3. 3. Install Floor Heating Cable following manufacturer’s instructions using our wire spacing chart. 
  4. 4. Cover with bonding agent and allow for tack time as specified by the manufacturer of the bonding agent, then pour Self Leveler.

 

RPM-V1 Concrete Installation summary:

Read Complete RPM-V1 Mats installation instructions for concrete

  1. 1. Spread Roberts 2001 Adhesive or equivalent on slab using 1/8x1/8 v-notch trowel
  2. 2. Fit and set RPM mats into adhesive butted to each other, cutting as needed, keeping studs aligned. Wait 24 Hours before installing cable and leveling
  3. 3. Install Floor Heating Cable following manufacturer’s instructions using.
  4. 4. Cover with bonding agent and allow for tack time as specified by the manufacturer of the bonding agent, then pour Self Leveler.

Download Wire Spacing Chart 

 

 

UPC RPM-V1
Size in Feet 1.66'ft. x 3.66'ft. (6.1 sq. ft.)
Size in Inches 20"in. x 44"in. (880 sq. in.)
Size in Meters 0.6 m x 1.22 m (0.73 sq. m.)
Manufacturer CMX Radiant Corp.
Warranty from Manufacturer 25 years
What's In The Box 1 RPM mat, instructions
Write Your Own Review
You're reviewing:RPM-V1 Radiant Positioning Mat with Holes 5/16" x 20" x 44" (6.11 Sq Ft)
Your Rating