ProMelt electric radiant snow melting mats install easily and quickly providing electrically heated driveways and walkways. Energy efficient and environmentally friendly snow and ice removal in the worst conditions is possible without using nasty chemicals or corrosive salt.
ProMelt heated snow melting mats are manufactured by SunTouch Watts Radiant (pioneers of indoor radiant heat) using superior quality snow melting cable attached to a reinforced tape grid simplifying installation while maintaining optimum spacing of cables. Plus, you can free the cable from the mat to fill in or fit steps, curved or angled spaces as needed.
ProMelt is an effective, reliable and invisible snow melting system that will serve you for many years. Typical projects of 300 SF or less simply require mats and a snow sensor-controller and are very affordable and convenient.
ProMelt Snow Melting Benefits:
285°F (140°C) Short-term max. for asphalt covering
30 or 50 Amps @ 240v, depending on controls chosen
70 A Breaker.
Attach ProMelt over cooled asphalt base layer- Cover with hand shoveled final asphalt layer min 1.5 inch thick-DO NOT DRIVE machines on exposed ProMelt. Roll with small roller or compactor. - See Installation Manual
Minimum 1.5 inches sand over cables, max paver thickness of 2.50 inches - See Installation Manual
Use Chairs/dobies so rebar/Mesh ProMelt is attached to is in top 2" of slab - See Installation Manual.
Maximum 2.50" total thickness over cables - See Installation Manual
Every 24" using plastic ties (no metal) for mesh, or nail through tape for surface
1.25" minimum - See Installation Manual and TCNA guidelines
1.50" inches below top of heated surface-completely covered : See Installation Manual
Minimum 6" from edge of slab or 12" for asphalt without a curb
|Heating Power Output Total||6800 BTU total|
|Heating Power Output per Hour (BTU)||170 BTU per Sq Ft/Hour|
|EMF (Electro Magnetic Field)||Yes. Verified by Independent Testing Laboratory as ultra low. REET test|
|Ohms Reading (resistance value)||26 - 32 ohms|
|Power Lead Type||Insulated, NEC color code, Single point connection at 1 corner of mat. No return wire like inferior products|
|Power Lead Length||20 Feet|
|Power Lead Wire Gauge||14 AWG|
|Thickness||1/4" in. inch|
|Spacing of Heating Wire||3" inches|
|Length of Heated Area (ft)||20' ft. feet|
|Length of Heated Area (in)||240" in. inch|
|Canadian Electric Code reference||Section 62 (CEC) Part I. Plus any local code requirements|
|National Electric Code reference||ANSI/NFPA 70 especially Article 426. Plus any local code requirements|
|Safety Listing||ETL Listed for U.S. and Canada under UL (Underwriters Laboratory) 515, IEEE 515.1, and CAN/USA C22.2 No. 130-03 : Listing file number: 3151992|
|Size in Feet||2' x 20' (2x20 feet)|
|Size in Inches||24" x 240" (24x240 inches)|
|Size in Meters||0.61m x 6.1m (0.61x6.1 meters)|
|Warranty from Manufacturer||10 Year backed by USA Manufacturer since 1873|
|Wattage per SF||50|
ProMelt Mats install faster and easier than any snow melting system in 3 easy steps once you have read all instructions, planned the electrical details, designed a layout and prepared your jobsite:
The ProMelt radiant heating mats are built tough for Permanent installation within virtually any surface to provide efficient melting of snow and ice automatically. They must be completely embedded and at least 1.25 inches below the top of the new layer.
|Wire Construction||ETFE Fluoropolymer, Braided copper ground plane, Foil shield and Outside polyurethane jacket|