DITRA-HEAT-DUO Insulated Membrane Roll 108 sq ft, 3'3" x 33' DHD810M
DITRA-HEAT-DUO provides a thermal break that ensures faster warm-up time of your floor, especially over concrete.
The DUO membrane also provides integrated sound control which reduces impact sound transmission to floors below, making it ideal for multi-story homes, condos and apartments.
Reduced heat loss to the substrate for up to 70% faster heat-up times over concrete when your floor heating thermostat activates the heating cables in DUO.
DITRA-HEAT by Schluter-Systems integrates electric floor warming with the functions associated with DITRA: uncoupling, waterproofing, vapor management, and support to ensure a long-lasting installation under tile or stone floors.
• Combines the flexibility of loose heating cables with the ease of installation of mat systems.
• Cables can be snapped into place wherever heat is desired, which significantly reduces installation time and effort.
• Tile directly over DUO or pour self-leveler over the top to install alternate floor coverings
- Engineered Wood, floating or glued-down
- Laminate
- Luxury Vinyl Tile & Plank (LVT/LVP)
- Vinyl
- WPC or Wood Plastic Composite core flooring
- SPC or Stone Plastic Composite core flooring
Waterproof your installation with KERDI-BAND (sold separately); cover all joints, seams, and corners of the membrane to completely waterproof the installation before applying thin-set and tile.
Instructions + Video
All substrates must be clean, even, and load bearing. Bond inhibiting surfaces must be removed prior to the application of DITRA-HEAT-DUO. For complete installation guidelines and warranty criteria, please refer to the downloadable Schluter®-DITRA-HEAT Installation Handbook and the installation video online. Note: Type, thickness, and format of the tile or stone surface covering must be suitable for the intended application. Minimum tile format is 2" x 2" (5 cm x 5 cm). 1. Apply thin-set mortar that is suitable for the substrate (mixed to a fairly fluid consistency, but still able to hold a notch) using the DITRA-HEAT trowel, or other 1/4" x 1/4" (6 mm x 6 mm) square-notched trowel. 2. Apply DITRA-HEAT-DUO to the floor, fleece side down. Solidly embed the matting into the mortar using a float, screed trowel, or DITRA-ROLLER, making sure to observe the open time of the bonding mortar. If the mortar skins over prior to matting installation, remove and reapply. 3. Lift up a corner of the matting to check coverage. Proper installation results in full contact between the fleece webbing and the thin-set mortar. Note: Coverage may vary with mortar consistency, angle at which the trowel is held, substrate flatness, etc. If full coverage is not achieved, remove and reapply, making sure to verify proper mortar consistency and application. 4. Abut end and side sections of adjacent sheets. Note: Aligning the studs on the top of the matting during installation can help make subsequent heating cable installation easier. Alternate Floor Coverings over DITRA-HEAT Please refer to detail DH-AFC (see the Technical Bulletin - DITRA-HEAT with Alternate Floor Coverings available in the Downloads tab above) and the Schluter®-DITRA-HEAT Installation Handbook for complete installation guidelines..
Note: Type, thickness, & format of the tile/stone covering must be at least 2" x 2" (5 x 5 cm).
dd
Specifications
| Manufacturer | Schluter-Systems |
|---|---|
| Thickness | 5/16" |
| Size in Feet | 107.25 sq ft |
More Details
| Warranty from Manufacturer | 10 Years |
|---|
Reviews