Manufactured by Schluter-Systems, EMF-cancelling DITRA-HEAT radiant heating cable installs directly into DITRA-HEAT or DITRA-HEAT-DUO cable installation membrane (sold separately) for use under tile or stone flooring.
Additional benefits include:
• 3-stud spacing is standard spacing (generates 12.7 Watts per square foot)
• NEW alternate spacing is now an option for more heat output
• Low profile of 4.8mm for cable and 5.5mm with membrane
• Compatible for shower floor and benchtop installation
• Significantly reduced installation time. No self-leveler required!
• 15-Year Manufacturer Warranty with opportunity to extend
Cable spacing of 3 studs is standard, but closer spacing of 3-2-3-2 provides more heat or allows you to “use up” extra cable if you have too much. 4 stud spacing is NOT recommended.
Running cable is more difficult/time consuming than installing mats.
All substrates must be clean, even, and load bearing. Bond inhibiting surfaces must be removed prior to the application of DITRA-HEAT.
Note: Minimum tile or stone format is 2" x 2" (5 cm x 5 cm).
For complete installation guidelines and warranty criteria, please refer to the downloadable Instruction Manual or scroll to the bottom of this page to view the installation video.
INTERIOR floor heating application only. Embedded in mortar or self leveler only
20 Amp Breaker
|Safety Listing||Listed under CAN/CSA-C22.2 No. 130-03.|
|Heated Area Size Covered||11|
|Wattage per SF||12.7 at 3-stud spacing|
|Heating Power Output per Hour (BTU)||460.64|
|Spacing of Heating Wire||Varies|
|Power Lead Length||7'|
|Power Lead Wire Gauge||18 AWG|
|Power Lead Type||Armored, NEC color code, Single point connection at 1 corner of mat. No return wire like inferior products|
|What's In The Box||(1) 10.7 sq ft 120V cable, (1) sensor wire|
|Warranty from Manufacturer||15-Year Limited Warranty|
|Acceptable Floor Coverings||Tile, Natural Stone|
|Heated SF 1||10.7|
|Heated SF 2||8.9|
|Watts Per SF 1||12.7|
|Watts Per SF 2||15.2|